Setting the Time & Date on a Nortel Norstar Telephone System

There are a couple of different ways access the time change feature, depending on the type of system you have.  A programming template is provided below if you need it.   Just cut-out the shaded areas as well as around the outside of the template.   Once cut, place the template over the top 2 rows of buttons on your 7310 or 7324 telephone (typically lines 1 and 2 on your telephone).


After you enter programming mode, all methods are pretty much the same.

Access type 1:   Press   * * TIME (8463)


Access type 2:   Press   * * ADMIN (23646)


System displays Password & then you should enter 23646


Display shows 1.Sys speed dial


Press Next Display shows 2. Names


Press Next Display shows 3. Time and date


Press Show Display shows Time 16:24


On the Softkey under the display it says CHANGE


If you wish to change the time, press CHANGE, if not press NEXT


Once you pressed the CHANGE button the hour displays;


If you wish to change the hour, press CHANGE, if not press NEXT


Once you pressed the CHANGE button the hour is erased allowing you to enter the new time - enter the new hour in 24 hour format, when OK press NEXT


Once you pressed the NEXT button the minutes display;


If you wish to change the minutes, press CHANGE, if not press NEXT


Once you pressed the CHANGE button the minutes are erased allowing you to enter the new time - enter the new minutes, when OK press NEXT


Follow the same procedure for changing the date!



Programming template

protemplate.bmp (147614 bytes)

Print this page, cut out the shaded areas with a utility knife and then cut around the outside box.  After you're done cutting, place the template over the top 2 rows on your 7310 or 7324 telephone.